15-6 FRX8000 3.0 User Guide, Rev 021 A value of 0 disables aging.2 If 0 is specified, the hard-coded MAC address of the LAN card will be used. If there areno LAN cards installed, a value other than 0 must be specified.3 Specifying 0 means that the DLCI is not assigned to a bandwidth allocation group.Set Bandw. Alloc. Group to 0 only if 0 is specified for all connec-tions on the same DLCI; otherwise, allocation will be unpre-dictable between assigned and unassigned traffic.Table 15-3 IPX Frame Relay Interface ParametersParameter Valid Values Default ValueBlocked Port Flag Y/N NInterface Type 0–5 1 (Ethernet)Frame Type 0 0 (TYPE_II)Maximum Transmission Unit 31–4096 4096Port Diagnostics Enabled Y/N YNetBIOS Enabled Y/N NNetBIOS Hops 0–255 8RIP Enabled Y/N YSAP Enabled Y/N YPeriodic RIP Enabled Y/N YPeriodic RIP Timer (seconds) 1–65535 60Periodic SAP Enabled Y/N YPeriodic SAP Tim er (seconds) 1–65535 60RIP Age Timer (seconds) 0–65535 1 180RIP Maximum Size (bytes) 54–446 446SAP Age Timer (seconds) 0–65535 1 180Tr ansport Time (55ms ticks) 0–255 1Serialization Enabled Y/N YWatchdog Spoofing Enabled Y/N NIPX Network Address 1–fffffffe 00000001IPX Node Address 0–fffffffffffe 2 000000000001IPXWAN Enabled Y/N NSource Card 0–7 0Source Port 0–63 0Source DLCI 16–991 16Bandw. Alloc. Group 0–16 3 1
