Configuring Inter-Nodal Trunks 7-3Configuring Trunk Port RecordsTo configure an N74/7500 port as a logical trunk, go to “Configuring N74/7500 PDNPorts” on page 7-11. To configure any other trunk type, press [A], then [C] from thePorts Selection Menu (or [A], [D], [A], [C] from the Main Menu). When prompted,enter:l Node ID (of the node containing the port): 1–250. (Default is the “local” node.)l LP ID (of the LP containing the port): 0–7. (Default is 0.)l Port: 0–7 for a physical port on an RLP, 0–3 for a port on an AST LP (N74/7500only), 8–63 for a logical port. (If configuring an FRX8000 logical port, enter theassociated physical X.25 or frame relay port number when asked.)l Any other requested information, noting the values in Table 7-1. (Press [Enter]at a prompt to specify the default value.)The display depends on whether you are configuring a trunk on a physical port with aV.25bis modem connected (Figure 7-2), a physical port with no V.25bis modem(Figure 7-3), or a logical port (Figure 7-4).Figure 7-2 Physical Trunk Port Record for V.25bis Port[A],[D],[A],[C] from Main MenuPort Main ten ance* Node I D 10 n ode10* LP ID 0 R LP* Port 1A Port Typ e 3 Trun kB Ph ysical I nterface 4 V .25Bis_D ialC Blocked Port Flag ND Lin e Speed Code 10 9600 bp sF Ou tstand in g Frames 2G N2 Maximum R etrans mis sions 5H T1 Retransmiss . Period -ms 2000I T2 Ackn owled g. Delay-ms 1000J T3 Link As surance Period-s 10K Propagation Delay-ms 0L Logical DC E YM Generate Clock YO Lin e Setup Retries 5P Remote Telephon e Numb er 8005551212Q Mod em INI String NameSelect:
