When Problems Occur 13-513 TroubleshootingThe density of the documents sent to a remote machine is too light.Q Is the Exposure setting set towards ' ' (Light) and the Original Type setting set to 'Photo'?A Change the Exposure setting to ' ' and (Dark), the Original Type setting to 'Text'. Try sendingthe document again. (See "Scan Exposure and Original Type Settings," on p. 3-15.)The machine will not transmit using a subaddress (if the optional Super G3 FAX Board is installed).Q Are the subaddress and password of the remote machine specified correctly?A Check to see if the machine has a subaddress function.A Check with the remote party to see if the specified subaddress and the RX password at boththis machine and the remote machine are the same.Q Has trouble occurred in the remote machine?A Check to make sure that the remote machine can receive documents. If it cannot, check tosee whether the recipient's machine has been turned OFF, is out of recording paper, or hasinsufficient available memory.Q Are the subaddress and password for the destination stored in the Address Book correct?A Check the subaddress and password settings for the destination stored in the Address Book.The remote machine is slow to switch over to the receiving mode, and errors always occur (if the optionalSuper G3 FAX Board is installed).Q Is a pause inserted in the fax number?A If you are sending to a machine that is slow in switching over to fax receiving, insert a pauseafter the destination's fax number.
