User Command Specifications ９．Details of command GET LEDILLUMINATE1 GET LEDILLUMINATEGET LEDILLUMINATEGET□LEDILLUMINATE?△LEDILLUMINATEg:LEDILLUMINATE=For all other responses, refer to "Error List."(1)However, a "busy" response is given while the zoom or focus lens is being driven.（ Refer to the ZCONTDRV command and FCONTDRV command. ）(2) LED lighting control can be set using the LEDILLUMINATE command.> GET LEDILLUMINATE or ? LEDILLUMINATE< g:LEDILLUMINATE=OFF*Commands are indicated by ">", and responses are indicated by "<".When a command is not supported, "e:000A INVALID_PARAMETER" is returned.Supported Command StatesOFF ON PMー ー ー× ○ ×*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.X600SX60○ ○ ○ ×○ ○ ○ ○SX6 ○ ○ ○- ー ー ーー ー ー -SX50 ー ー ーS-Video D-Video SCART NoneModeRemote Local RemarksModel Power supply InputD-RGB A-RGB1 A-RGB2 Comp Video× ○ ○ ○０１．０１** ０１．０１** ０１．０１**MeaningX600OFFSX50 SX6 SX60SettingControlModeResponseSettingONCommandsFunctionFormatEmotional LED and signal sensing LED lighting setting inquiryＩＤReferenceCommandssupportedThis sets the LED display to ON.This sets the LED display to OFF.This command is used to inquire about the current emotional LED and signal sensing LED lighting controlsettings.This inquiry can be made when the projector is in both the remote mode and power-on status atthe same time.ExampleDescription０１．００**PAGE 117
