|
User Command Specifications 9. Details of command NOSHOW1 NOSHOWNOSHOWNOSHOW= ：ＩＤ>Parameters for setting display screen in no show status-1A "busy" response is given while the zoom or focus lens is being driven.-2Menu[Display settings] - [User screen settings] - [Screen in no show status][Display settings] - [User screen settings] - [Screen in no show status]-3-4Setting> NOSHOW=LOGO This sets the “User” screen when nothing is displayed.< OkReference> GET NOSHOW or ?NOSHOW This retrieves the screen shown when nothing is displayed.< g:NOSHOW=LOGOAcquisition of parameters which can be set> RANGE NOSHOW< r:NOSHOW=BLACK,BLUE,LOGO* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.* "i:BUSY" may be returned if the power status is being switched.For details, refer to the GET command."BLACK," "BLUE" or "LOGO" can be set for the displayscreen in the no show status.01.00** 01.01** 01.01**SX6SX60X600The GET command can be used to obtain the current display screen when nothing is shown."i:OK" is returned if the parameter was set properly.This command is used to set the screen which is to appear in the no show status.ModelSX50It can be executed when the projector is in both the remote mode and power-on status at thesame time.(Refer to the ZCONTDRV command and FCONTDRV command.)CommandsFunctionParameterDisplay screen setting when nothing shownMode Control ReferenceSettingExampleSX50 SX6 SX60 X600Model Power InputLocalSCART None RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-VideoModeRemoteSX50 ○ ○ ○ ○ ○ ○ –○– ×SX6 ○ ○ ○ ○ ○ ○SX60X600×○ ○○○ ○FormatParameterBlack screenBLACKLOGO User screen IDFor details, refer to the RANGE command.○ ○ ○01.01**○MeaningResponseCommandssupportedDescriptionBLUE Blue screenFor all other responses, refer to "Error List."This command is the same as the menu functions in the table below.To select the user screen (LOGO), the user image must be registered ahead of time. (If theuser image is not registered, "e:1002 NO_LOGO_CAPTURED" is returned.)The parameters which can be set at any given point in time can be obtained using theRANGE command.PAGE 56
|
