User Command Specifications 9. Details of command HPOS/VPOS1 HPOS/VPOSHPOS/VPOSHPOS=VPOS=Horizontal/vertical positions-1A "busy" response is given while the zoom or focus lens is being driven.Furthermore, it may not be possible to execute the command with some input signals.-2Menu[Display settings] - [Input signal settings] - [Horizontal position][Display settings] - [Input signal settings] - [Vertical position]-3Setting> HPOS=12 This sets the horizontal position to 12.< i:OKReference> GET VPOS or ?VPOS This acquires the vertical position.< g:VPOS=8Obtain settable parameter range (Min, Max)> RANGE HPOS< r:HPOS=N, 0, 820* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.* "i:BUSY" may be returned if the power status is being switched.It can be executed when the projector is in both the remote mode and power-on status at thesame time.SX60 X600SX50 SX6CommandsFormatModeThe GET command can be used to retrieve the current horizontal and vertical position.SX60X600This command is the same as the menu functions in the table below."i:OK" is returned if the parameter was set properly.This adjusts the horizontal and vertical position on the screen.FunctionExampleModelSX50SX6ParameterResponseNumberFor all other responses, refer to "Error List."Description01.00** 01.01** 01.01** 01.01**Model Power InputD-RGB A-RGB1 A-RGB2 Comp Video S-VideoModeRemote Local RemarksD-Video SCART NoneSX50 × ○ ○ × × × – – × ○ ×SX6 × ○ ○ × ○ ×× × × ×SX60X600×Control Setting ReferenceFor details, refer to the RANGE command.Horizontal/Vertical position adjustmentThe RANGE command can be used to obtain the parameter range that can be set atthat time.[Display settings] - [Input signal settings] - [Horizontal position][Display settings] - [Input signal settings] - [Vertical position]Commandssupported(Refer to the ZCONTDRV command and FCONTDRV command.)For details, refer to the GET command.Any value from 0 to 820 can be set for thehorizontal position.○ ○ ○ ○PAGE 23
