User Command Specifications 9．Details of command GET DOTS1 GET DOTSGET DOTSGET□DOTS?△DOTSg:DOTS=For all other responses, refer to "Error List."-1A "busy" response is given while the zoom or focus lens is being driven.（Refer to the ZCONTDRV command and FCONTDRV command.）With some input signals, it may not be possible to make this inquiry.-2 The total number of dots can be set by the DOTS command.> GET DOTS or ? DOTS< g:DOTS=1200* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.* "i:BUSY" may be returned if the power status is being switched.× × ○ ×– × ○X600SX60× × ×SX6 × ○ ○ ××SX50 × ○ ○ × × ×RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NonePower Input ModeRemote LocalNumber○ ○ ○ ○This inquires about the current total number of dots.01.00** 01.01** 01.01** 01.01**CommandsFunctionFormatDescriptionResponseTotal number of dots inquiryMode Control Setting Reference–CommandssupportedThis inquiry can be made when the projector is in both the remote mode and power-on status atthe same time.ExampleSX60 X600SX50 SX6ModelPAGE 77
