User Command Specifications 9. Details of command VKS/HKS1 VKS/HKSVKS/HKSVKS=HKS=Vertical/horizontal keystone distortion valuesThis sets the vertical and horizontal keystones.-1A "busy" response is given while the zoom or focus lens is being driven.-2-3-4-5-6Setting> VKS=-23 This sets the vertical keystone to –23.< i:OK> HKS=10 This sets the horizontal keystone to 10.< i:OKReference> GET VKS or ?VKS This retrieves the vertical keystone.< g:VKS=-23> GET HKS or ?HKS This retrieves the horizontal keystone.< g:HKS=-23Obtain settable parameter range (Min, Max)> RANGE HKS< r:HKS=N,-30,30* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.* If the necessary signals are not input, 'NO_SIGNAL' is returned.* "i:BUSY" may be returned if the power status is being switched.01.00**The GET command can be used to obtain the current vertical/horizontal keystone value.X600○ ○Setting ReferenceSX60DescriptionResponse "i:OK" is returned if the parameter was set properly.This command is identical to pressing the “KEYSTONE” button on the remote control or front paExampleSX50 SX6CommandsChanging the vertical keystone value modifies the setting range of the horizontal keystonevalue, and changing the horizontal keystone value modifies the setting range of the verticalFunctionParameterNumberVertical/Horizontal keystone settingCommandssupportedMode Control01.01** 01.01** 01.01**○ ○Model Power Input ModeRemote Local RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 ○ ○ ○ ○ ○ ○ – – × ○ ×SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×SX60X600FormatFor details, refer to the RANGE command.For all other responses, refer to "Error List."(Refer to the ZCONTDRV command and FCONTDRV command.)It can be executed when the projector is in both the remote mode and power-on status at thesame time.The RANGE command can be used to obtain the parameter range that can be set atthat time.The settable keystone range varies depending on the input signal, screen size, number ofhorizontal and vertical dots, and other factors.Use the “RANGE” command to obtain the range of settable values immediately before settingthe vertical value and horizontal value.For details, refer to the GET command.Any value from -30 to 30 can be set for the horizontalkeystone distortion.PAGE 48
