User Command Specifications 9．Details of command RANGE HUE1 RANGE HUERANGE HUERANGE□HUEr:HUE=N, , -1A "busy" response is given while the zoom or focus lens is being driven.With some input signals, it may not be possible to make this inquiry.-2> RANGE HUE< r:HUE=N, -20, 20* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.* "i:BUSY" may be returned if the power status is being switched.01.01** 01.01**CommandssupportedSX50 SX601.00** 01.01**○ ○ ○Control Setting ReferenceFor all other responses, refer to "Error List."Hue setting range requestModeThis inquires about the range within which the hue can be set.NumberSX60 X600This inquiry can be made when the projector is in both the remote mode and power-on statusat the same time.(Refer to the ZCONTDRV command and FCONTDRV command.)The hue can be set by the HUE command.CommandsFunctionFormatExampleDescriptionResponse○Model Power Input ModeRemote Local RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 × ○ × –× × × ○ ○ ○ ×– ○ ○ ×– – –SX6× × ×○ ○× × ×○SX60 ○ ×X600 –– –×○○ ×PAGE 148
