User Command Specifications 9．Details of command GET MODE1 GET MODEGET MODEThis inquires about the current control mode.-1-2-3a.b.> GET MODE or ?MODE< g:MODE=REMOTE* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM○ ○ ○○ ○ ○X600SX60○ ○ ○ ○○ ○ ○ ○SX6 ○ ○ ○– ○ ○ ○SX50 ○ ○ ○RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneModel Power Input ModeRemote Local○ ○ ○ ○01.00** 01.01** 01.01** 01.01**CommandsFunctionFormatResponse○ ○ ○ –X600SX50 SX6Mode MeaningFor details on the control modes of the user commands, refer to the control mode.This inquiry can be executed in any status provided that AC power is supplied to the projector.CommandssupportedCurrent control mode inquiryMode ControlGET□MODE?△MODESX60ExampleDescriptionIDThe local mode is currently established.The remote mode is currently established.LOCALREMOTEg:MODE=：ＩＤ>When the power management mode has been established (standby, power off)The control mode is usually switched by REMOTE command-LOCAL command, but when the nextevent occurs in the remote status, the mode is switched to the local status.Setting ReferenceWhen the POWER button on the remote control or main unit panel has been pressed twice(power off operation)For all other responses, refer to "Error List."PAGE 73
