User Command Specifications 9. Details of command SHARP1 SHARPSHARPSHARP=Sharpness setting (-4 to 4)-1A "busy" response is given while the zoom or focus lens is being driven.-2Menu[Image adjustments] - [Sharpness][Image adjustments] - [Sharpness]-3-4Setting> SHARP=3 This sets the contrast to 3.< i:OKReference> GET SHARP or ?SHARP This retrieves the contrast.< g:SHARP=3Obtain settable parameter range (Min, Max)> RANGE SHARP< r:SHARP=N, -4, 4 Any value from -4 to 4 can be set for the sharpness.* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.* "i:BUSY" may be returned if the power status is being switched.The RANGE command can be used to obtain the parameter range that can be set atthat time.It can be executed when the projector is in both the remote mode and power-on status at thesame time.SX50SX601.01**"i:OK" is returned if the parameter was set properly.LocalSCART NoneModel Power InputExampleSX50 SX6 SX60 X600CommandsFunctionParameterDescriptionResponseFormatModeThis sets the screen sharpness.ModelControl Setting ReferenceFor details, refer to the RANGE command.NumberSharpness settingFor all other responses, refer to "Error List."RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-VideoModeRemoteSX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×SX6 ○ ○ ○ ×○ ○ ○ ○ ○ ○ ○SX60X600This command is the same as the menu functions in the table below.This sets the currently selected input signal and image mode.The current sharpness can be acquired using the applicable GET command.SX60X600○(Refer to the ZCONTDRV command and FCONTDRV command.)For details, refer to the GET command.Commandssupported○ ○ ○01.00** 01.01** 01.01**PAGE 31
