User Command Specifications 9.Details of command RGBGAIN1 RGBGAINRGBGAINRGBGAIN=▽▽RGB gain settings (from -20 to 20 for each value)The RANGE command can be used to obtain the parameter range that can be set at that time.For details, refer to the RANGE command .For all other responses, refer to "Error List."This command is used to adjust the gain of the R, G and B colors.(1)However, a "busy" response is given while the zoom or focus lens is being driven.( Refer to the ZCONTDRV command and FCONTDRV command. )(2)(3)(4)For details, refer to the GET command .Setting> RGBGAIN=10, 11, 12 The R gain is set to 10, G gain to 11 and B gain to 12.< i:OKReference> GET RGBGAIN or ?RGBGAIN The RGB gain values are obtained.< g:RGBGAIN=-10, 0, 19Obtain settable parameter range (Min, Max)> RANGE RGBGAIN< r:RGBGAIN=N,-20,20,-20,20,-20,20*Commands are indicated by ">", and responses are indicated by "<".When a command is not supported, "e:0002 INVALID_COMMAND" is returned.Supported Command StatesOFF ON PM- - -× ○ ×*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.Commandssupported 01.01** 01.01**This sets the currently selected input signal and image mode.A number from -20 to 20 can be set for each color asthe RGB gain values.CommandsFunction RGB gain adjustmentDescriptionResponseParameterSetting ReferenceControlModeThis command functions in the same way as when "Image adjustments" - "Color adjustments" -"Red/green/blue gain" are selected on the menu.The current RGB gain values can be obtained using the GET command.It can be executed when the projector is in both the remote mode and power-on status at the sametime.○ ○ ○ExampleSX50 SX6 SX60 X60001.00** 01.01**Model Power supply Input ModeRemote Local×RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 - - - - - - - - - - -SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×SX60X600Format"i:OK" is returned if the parameter was set properly.NumberPAGE 40