User Command Specifications ９．Details of command RANGE DPON1 RANGE DPONRANGE DPONRANGE□DPONr:DPON=I, , , …, For all other responses, refer to "Error List."(1)However, a "busy" response is given while the zoom or focus lens is being driven.（ Refer to the ZCONTDRV command and FCONTDRV command. ）(2) Direct power-on can be set using the DPON command .> RANGE DPON< r:DPON=I, ON, OFF*Commands are indicated by ">", and responses are indicated by "<".When a command is not supported, "e:000A INVALID_PARAMETER" is returned.Supported Command StatesOFF ON PMー ー ー× ○ ×*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.This inquiry can be made when the projector is in both the remote mode and power-on status atthe same time.CommandssupportedExampleX600SX60○ ○ ○ ×○ ○ ○ ○SX6 ○ ○ ○- ー ー ーー ー ー -SX50 ー ー ーRemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneModel Power supply Input ModeRemote Local× ○ ○ ○０１．００** ０１．０１** ０１．０１** ０１．０１**ReferenceSX50 SX6 SX60 X600SettingControlModeＩＤDescriptionResponseThis command is used to inquire about the parameter options which enable direct power-on to be set.CommandsFunctionFormatDirect power-on setting inquiryPAGE 171
