User Command Specifications ９．Details of command FCONTDRV1 FCONTDRVFCONTDRVFCONTDRV=Focus lens continuous control parametersFor details, refer to the RANGE command .For all other responses, refer to "Error List."This command is used to drive the focus lens.(1)（ Refer to the ZCONTDRV command and FCONTDRV command. ）(2)(3)(4) ▼a. REMOTEb. LOCALc. POWERd. FCONTDRV=STOP(5)a. GET MODE e. GET PRODCODEb. GET POWER f. GET ROMVERc. GET ERR g. GET COMVERd. GET LAMPCOUNTER(6)Control> FCONTDRV=NEAR Control over the focusing to the near end is started.< I:OKRange acquisition> RANGE FCONTDRV< r:FCONTDRV=I, STOP, FAR, NEARWhen a command is not supported, "e:0002 INVALID_COMMAND" is returned.Supported Command StatesOFF ON PM－ － －× ○ ×*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.CommandssupportedThe parameters which can be set at any given point in time can be obtained using theRANGE command.It can be executed when the projector is in both the remote mode and power-on status at the sametime.However, only the "STOP" parameter takes effect while the focus lens is being driven, and a "busy"response is given while the zoom lens is being driven.The following commands are acknowledged during focus drive, and a response is returned while thedrive continues.X600MeaningThis stops the focusing.This initiates focusing toward the far end.This initiates focusing toward the near end.Focus lens continuous drive control"i:OK" is returned when the drive was completed successfully.Example０１．００** ０１．０１** ０１．０１**ＩＤParameterNEARSTOPCommandsFunctionParameterDescriptionResponseFormatControl Setting ReferenceModeFARThis command functions in the same way as when first the "FOCUS" button on the remote controlor main unit panel is pressed and then the "↑" or "↓" button is pressed.Focus drive is started by specifying "NEAR" or "FAR." To stop the drive, add the "STOP"parameter and send this command.If no instruction was given to stop the drive, the drive stops at the drive direction end.Focus drive stops when the "POWER" button on the remote control or main unit panel is pressedduring focus drive."STOP," "FAR" or "NEAR" can be set for focuslens continuous drive.The following commands are acknowledged during focus drive, but focus drive will also stop at thesame time.In the case of any other commands, "i:BUSY (FOCUS)" is returned unconditionally, and focus drivecontinues.SX50 SX6 SX60○ ○ ○０１．０１**Model Power supply Input ModeRemote Local×RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 － － － － － － － － － － －SX6 ○ ○ ○ ○ ○ ×○ ○ ○ ○SX60X600○PAGE 68
