User Command Specifications 9．Details of command RANGE CONT1 RANGE CONTRANGE CONTRANGE□CONTr:CONT=N, , -1A "busy" response is given while the zoom or focus lens is being driven.-2> RANGE CONT< r:CONT=N, -20, 20* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.* "i:BUSY" may be returned if the power status is being switched.CommandssupportedFor all other responses, refer to "Error List."This inquiry can be made when the projector is in both the remote mode and power-on statusat the same time.(Refer to the ZCONTDRV command and FCONTDRV command.)The contrast can be set by the CONT command.01.01** 01.01** 01.01**○ ○SX50 SX6This inquires about the range within which the contrast can be set.01.00**SX60NumberMode Control Setting ReferenceCommandsFunctionFormatExampleDescriptionResponseContrast setting range requestModel Power Input ModeRemote Local RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 ○ ○ ○ – ○ ○ ×○ ○ ×○ ○ ○ ○X600○SX6 ○ ○ ○SX60X600○ ○ ○○ ○–PAGE 140
