User Command Specifications 9．Details of command RANGE SAT1 RANGE SATRANGE SATRANGE□SATr:SAT=N, , -1A "busy" response is given while the zoom or focus lens is being driven.With some input signals, it may not be possible to make this inquiry.-2> RANGE SAT< r:SAT=N, -20, 20* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.* "i:BUSY" may be returned if the power status is being switched.CommandssupportedFor all other responses, refer to "Error List."This inquiry can be made when the projector is in both the remote mode and power-on statusat the same time.(Refer to the ZCONTDRV command and FCONTDRV command.)The color saturation can be set by the SAT command.○ ○ ○ ○01.00** 01.01** 01.01** 01.01**CommandsFunctionFormatExampleDescriptionResponseSX6This inquires about the range within which the color saturation can be set.NumberSX60 X600Color saturation setting range requestMode Control Setting ReferenceModel Power Input ModeNone Remote Local RemarksD-RGB A-RGB1SX50A-RGB2 Comp Video S-Video D-Video SCARTSX50 × × × ○ ○ ○ – – ×SX6 × × × ○ ○ ○ × ○ ○○ ○SX60××X600PAGE 147
