User Command Specifications 9. Details of command IMAGEFLIP1 IMAGEFLIPIMAGEFLIPIMAGEFLIP= ：ＩＤ>Image flip setting parametersFlip horizontallyFlip verticallyFlip horizontally and vertically-1A "busy" response is given while the zoom or focus lens is being driven.-2Menu[Display settings] - [Flip display][Display settings] - [Flip display]-3-4Setting> IMAGEFLIP=REAR< i:OKReference> GET IMAGEFLIP or ?IMAGEFLIP This retrieves the flip display state.< g:IMAGEFLIP=REAR_CEILINGAcquisition of parameters which can be set> RANGE IMAGEFLIP<* Commands are indicated by ">", and responses are indicated by "<".Supported Command StatesOFF ON PM× ○ ×× ○ ×* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.* "i:BUSY" may be returned if the power status is being switched.ModelSX50SX6SX60X600○SX50r:IMAGEFLIP=I,NONE,CEILING,REAR,REAR_CEILINGResponse "i:OK" is returned if the parameter was set properly.This command is used to flip the screen display in various ways (vertically or horizontally).CEILINGREARRear ceilingFor details, refer to the RANGE command.For all other responses, refer to "Error List."REAR_CEILINGThis command is the same as the menu functions in the table below.The current flip display status can be acquired using the applicable GET command.DescriptionIt can be executed when the projector is in both the remote mode and power-on status at thesame time.When the display is flipped, the "keystone distortion" settings are initialized (set to HKS:0,VKS:0).CommandsFunctionParameterFlip displayIDFormatMode Control Setting ReferenceExample01.00** 01.01** 01.01** 01.01**SX6 SX60 X600Model Power Input ModeRemote Local RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×SX6 ○ ○ ○ ○ ○ ×○ ○ ○ ○SX60X600○RemarksThe parameters which can be set at any given point in time can be obtained using theRANGE command.MeaningNoneCeilingRearParameterNONE"NONE," "CEILING," "REAR" or "REARCEILING" can be selected as the flipdisplay setting.Commandssupported(Refer to the ZCONTDRV command and FCONTDRV command.)For details, refer to the GET command.This displays the image backwards (flipvertically) on the screen.○ ○ ○PAGE 52
