User Command Specifications 9. Details of command GUID1 GUIDEGUIDEGUIDE=Guide setting parametersFor details, refer to the RANGE command .For all other responses, refer to "Error List."This command is used to set the guide function display to ON or OFF.(1)However, a "busy" response is given while the zoom or focus lens is being driven.（ Refer to the ZCONTDRV command and FCONTDRV command. ）(2)However, the guide is cleared immediately when "GUIDE=OFF" is received while the guide is displayed.(3)For details, refer to the GET command .Setting> GUIDE=ON The guide display is set to ON.< i:OKReference> GET GUIDE or ?GUIDE The guide display setting status is obtained.< g:GUIDE=ONAcquisition of parameters which can be set> RANGE GUIDE< r:GUIDE=I, OFF, ON*Commands are indicated by ">", and responses are indicated by "<".When a command is not supported, "e:0002 INVALID_COMMAND" is returned.Supported Command StatesOFF ON PM－ － －× ○ ×*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.Commandssupported ０１．００** ０１．０１** ０１．０１** ０１．０１**X600OFF Guide display OFFThe parameters which can be set at any given point in time can be obtained using theRANGE command.It can be executed when the projector is in both the remote mode and power-on status at the sametime.ModeＩＤReferenceParameter MeaningControl SettingGuide settingON Guide display ONExample"i:OK" is returned if the parameter was set properly.ResponseThis command functions in the same way as when "System settings" - "Guide" are selected on themenu.The current guide setting can be obtained using the GET command.CommandsFunctionParameterDescriptionFormat○ ○ ○SX50 SX6 SX60Model Power supply Input ModeRemote Local×RemarksD-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART NoneSX50 － － － － － － － － － － －SX6 ○ ○ ○ ×○ ○ ○ ○ ○ ○ ○SX60X600PAGE 62
