Chapter 77-45F-7-1253) Remove the dust-collecting roller arm [1] and the twisted spring [2]; then,detach the dusts-collecting roller [3].F-7-1267.10.19 Charging Wire7.10.19.1 Outline 0010-8934iR7105 / iR7095 / iR7086As many as 3 charging wires are found around the photosensitive drum (pri-mary, pre-transfer, transfer/separation); these wires are 0.06 mm in diameter.7.10.19.2 Removing the Wire Cleaner for the PrimaryCharging Assembly 0010-8935iR7105 / iR7095 / iR70861) Remove the primary charging assembly.2) Move the clip base [1] fully to the rear, and remove the screw [2]; then,remove the support plate [4] of the wire clean motor shaft [3], and detachthe clip base [1] from the cut-off [6] of the shielding plate [5] togetherwith the wire cleaner motor shaft [3].F-7-1273) Pick the wire cleaner with small pliers, and free the hook with your fin-gers.F-7-1287.10.19.3 Removing the Wire Cleaner of the TransferSeparation Charging Assembly 0010-8940iR7105 / iR7095 / iR70861) Remove the transfer/separation charging assembly.2) Move the felt holder [1] to the front as far as it moves.F-7-1293) Remove the motor cover [1] together with the motor.F-7-1304) Remove the E-ring [1]; then, pull the screw [2] to the front, and remove itupward.[1][1][2][1][2][3][3][2] [4][1][5][6][6][1][1]
