Chapter 1717-63DNSTRANS***Switching the priority of DNS transfer1Determine the priority of protocol (IPv4/IPv6) used for DNS inquiry based on the DNStrans value.Setting range0: ipv4, 1: ipv6Method of AdjustmentWhen DNS query is first executed for IPv6 in the environment where both IPv6 and IPv4 are used and the DNS server only supportsIPv4, timeout occurs and it takes time. In such a case, execute this mode to set priority to IPv4.MIBCOUNT***Charging counter MIB switch1Change the scope range of the charging counter MIB.Setting range0: Display all charging counter MIB information.1: Display all charging counter MIB information that is displayed in LUI.2: Do not display charging counter MIB information.Method of AdjustmentWhen the charging counter MIB is not disclosed, request a serviceman to change the counter value.[Value after execution of RAM clear: 0]RMT-CNSL***Meap Remote Console switch1When the service personnel take the Function Composer log in the field, turn on this switch and execute logging with RemoteConsole.0: OFF [default]1: ONIDL-MODE Use it to enable/disable the mechanism that computes the scan area based on the selected paper size.2It aims to increase the charging level by idling of the developing cylinder.It works with COPIER>OPTION>BODY>DEV-IDLR.Setting0: OFF (Not idling)1: Auto control by the environment sensor [Default]2: Start idling at the point that the temperature of the fixing roller became 100 deg C.3: Start idling at the main power switch ON.Usage:When there is dropping of toner from the photosensitive drum separation claw and the density becomes thin due to a long period ofleaving or the high-temperature environment, the following settings are recommended.Setting value of COPIER>OPTION>BODY>DEV-IDLR: '1'Setting value of COPIER>OPTION>BODY>IDL-MODE: '2'MEMO:Do not use for servicing.SCANSLCT Use it to enable/disable computation of the scan area with reference to selected paper size.2settings0: off (determine scan area based on original detection; default)1: on (determine scan area based on paper size)When setting as '1', if the media size is larger than the original size, productivity decreases due to a larger scanning area.OHP-TEMP Use it to switch over the transparency mode temperature control setting.2Decreases the fixing temperature to facilitate separation of transparencies from the fixing roller.0: 198 deg C (default) 1: 193 deg C 2: 188 deg C 3: 183 deg CCOPIER > OPTION > BODY*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).**: model equipped with DADF-M1 (outside Japan: iR7086).***: up graded versionSub item Description Level
