Chapter 1313-7F-13-313.3.3 Scheduled Maintenance Work Procedure 0010-9514iR7105 / iR7095 / iR7086Perform the following to service the area around the drum as part of scheduled maintenance:Work 1a. cleaning the side scraper assemblyb. cleaning the toner receptacleDo not rotate the magnet roller drive assembly during the work. Doing so could cause waste toner to drop from the cleaner assembly.1) Slide out the process unit.Be sure to place paper over the fixing/transport unit.2) Take out the photosensitive drum.3) Remove the cleaning blade assembly.sub thermistor replacethermal switch replaceOptical sensor sensor clean If high temperature/humidity, every250,000 prints.reflecting prism clean If high temperature/humidity, every250,000 prints.Waste toner waste toner case inspect Inspect/remove.Waste case Transfer guide cleanPickup/transfer assembly registration roller(upper, lower)cleantransport belt cleandelivery upper separation claw replacedelivery lower separation claw replacetransport rollers cleanDuplexing assembly duplexing horizontalregistration sensorcleanduplexing rubber roller cleanUnit name Location Maintenance intervals Remarksupon installation every 500,000printsevery 1,000,000printsOzone filterfor FM2Ozone filerfor FM20Ozone filterfor FM8Dust filterfor FM502Dust filterfor FM501Dust filter for FM10Dust filterfor FM1Dust filterfor front coverDust filterfor FM3Ozone filterfor FM2Ozone filter for FM20Ozone filterfor FM8Dust filterfor FM501Dust filterfor FM10Dust filterfor FM1Dust filterfor front coverDust filterfor FM3Other than the iR7086 iR7086
