Chapter 88-478.11.22.3 Removing the Front Cover of the DuplexingUnit 0010-9341iR7105 / iR7095 / iR70861) Remove the 4 screws [1] and the knob [2]; then, detach the front cover [3].F-8-1278.11.22.4 Removing the Duplex Left Feed Motor 0010-9346iR7105 / iR7095 / iR70861) Remove the duplex feed fan unit.2) Loosen the screw [1]; then, while pulling the tension support plate [2]in the direction of the arrow, tighten the screw [1] (to loosen the tensionof the belt [3]).3) Disconnect the connector [4], and remove the 2 screws [5]; then, de-tach the duplex left feed motor [6].F-8-1288.11.22.5 Removing the Duplex Right Feed Motor 0010-9349iR7105 / iR7095 / iR70861) Remove the front cover of the duplex unit. (4 screws, 3 knobs)2) Loosen the screw [1]; then, while pulling the tension support plate [2]in the direction of the arrow, tighten the screw [1] (to loosen the tensionof the belt [3]).3) Disconnect the connector [4], and remove the 2 screws [5]; then, de-tach the duplex right feed motor [6].F-8-1298.11.22.6 Removing the Reversing Flapper Solenoid 0010-9355iR7105 / iR7095 / iR70861) Remove the duplexing unit from the main body.2) Remove the two screws [1], and disconnect the connector [2]; then, de-tach the reversing flapper solenoid [3].F-8-1308.11.22.7 Removing the Left Deck Feed Sensor 0010-9360iR7105 / iR7095 / iR70861) Slide out the duplex unit assembly.2) Remove the screw [1], and detach the sensor base [2].F-8-1313) Disconnect the connector [1], and free the claw to detach the left deck feedsensor [2].F-8-132When removing the scanner sensor, be sure to remove the paint used to lockthe claw in place in advance to prevent breaking the claw. When mountingit, be sure the claw is not displaced or the sensor is not disoriented.8.11.22.8 Removing the Horizontal Registration Motor 0010-9361iR7105 / iR7095 / iR70861) Remove the duplexing unit from the main body.2) Remove the two screws [1], and detach the upper cover [2].[3] [2] [1][1][3] [1][6][5] [2] [4][1][6][5][5][2] [4][3][1] [1][2] [3][1][2][2][1]
