Chapter 22-16F-2-402) Remove the fixing [1] (1 screw [2]), and disconnect the connector [3].F-2-413) While holding the front side of the transfer separation charging assembly[1] and A part, pull it out approx 1 cm, and then detach it in upper left di-rection.Clean the transfer separation charging wire using alcohol.F-2-424) Mount the transfer separation charging assembly [1] while keeping thefollowing in mind:- all solvent must be fully dry.- the gut wire must not be in contact with the transfer guide [2] to avoid acut.- the grounding plate [3] must be outside the charging assembly frame[4].F-2-435) Connect the connector of the transfer separation charging assembly, andfit the fixing in place.6) Attach the transfer separation charging assembly front cover.7) Return the fixing feed unit inside the device and return the fixing feed unitrelease lever [1] in the original place.F-2-448) Remove the primary charging assembly front cover [1].- screw [2]F-2-459) Disconnect the connector [1] and press the primary charging assemblylock lever [2] to release it, and then remove the primary charging assem-bly [3].Clean the primary charging wire and the grid wire using alcohol.[1][2][1][2][3][1][2][1] [2][1][2][1]
