Chapter 88-46F-8-1204) Remove the two screws [4], and detach the fixing feeding unit releasinglever support plate [5].F-8-1215) Remove the E-ring [6], bearing [7], and three screws [8].F-8-1226) Remove the E-ring [9], gear [10], pin [11], three screws [12], E-ring [13],and bearing [14].F-8-1237) Remove the feeding belt unit [15], and detach the feeding belt [16] and thepostcard belt [17].F-8-1248.11.22 Duplexing Unit8.11.22.1 Removing the Duplexing Unit 0010-9323iR7105 / iR7095 / iR70861) Slide out the duplexing unit from the main body.2) Holding the left and right grips of the duplexing unit, detach it from themain body.F-8-125Take care not to trap your hand between the grip and the rail. Do not placethe duplexing unit where it is subjected to damage.8.11.22.2 Removing the Reversal Motor 0010-9336iR7105 / iR7095 / iR70861) Remove the duplex feed fan unit.2) Loosen the screw [1]; then, while pulling the tension support plate [2]in the direction of the arrow, tighten the screw [1] (to loosen the tensionof the belt [2]).3) Disconnect the connector [4], and remove the 2 screws [5]; then, de-tach the reversal motor [6].F-8-126[2][1][1][3][4] [4][5][8] [6] [7][11][12][9][14][13][10][17][15][16][16]Duplexing unit GripGrip[2][1] [3] [6][5][5] [4]
