Chapter 22-28F-2-10812) Route the control panel interface cable [2] through the hole in the armcover [1].13) Keep the control panel interface cable along the cable guide [3], and fitit in the groove of the arm cover.14) While hooking the claw [4] of the arm cover on the cut-off [5] of the armunit, put the arm cover over it.F-2-10915) Remove the screw [1], and detach the rear support cover [3] of the con-trol panel unit [2].F-2-11016) Fit the control panel unit [1] in place to the arm unit.- 1 flat-head screw (M4X10) [2]- 1 screw (W sems; M4X12) [3]F-2-11117) Fit the rear support cover [2] removed in step 16) to the control panel [1]using the screw [3] removed also in the same step.F-2-11218) Fix the arm cover [1] in place.- 2 screw (P tightening; M4X10) [2]F-2-11319) Mount the arm lower cover [1].- 1 screw (binding; M4X10) [4],Match the wire saddle at the rear and the marking [3].Be sure that the cable guide [3] is oriented so that the side with a protrusion(thicker end) is downward.Note that the cable guide [3] divides itself into two during the work. The factwill not affect its function, and the work may be continued.[1][2] [3][3][2][4][5][1][1][2][3][3][2][1][3][2][1][2][1]
