Chapter 22-36F-2-1493) Move the cassette guide assembly (front) [1] to the front or the rear tomake adjustments.- move the guide plate to the rear to decrease the horizontal registration(left margin).- move the guide plate to the front to increase the horizontal registration(left margin).F-2-1504) heck to make sure that the horizontal registration (left/right margin) onprints using the front deck (left/right) is 2.5 +/-1.5 mm.F-2-151[1] Paper movement5) Tighten the 4 screws you loosened in step 2).6) Put the front deck (left/right) back in place.1) Move the side guide plate [1] to the center, and loosen the 2 manual feedertray mounting screws [2]; then, adjust the position of the manual feedertray.F-2-1521) Make the following selections in service mode: COPIER > ADJUST >FEED-ADJ > ADJ-REFER so that the image margin on the 2nd side willbe as indicated.2) Exit the service mode.- if the margin is too large, decrease the setting of ADJ-REFER (a changeof 10 will decrease the margin by 1 mm).- if the margin is too small, increase the setting of DJ-REFER (a changeof 10 will increase the margin by 1 mm).W1=2.5 +/-2.0 mmF-2-153[1] Paper movement2.2.23 Adjusting the Lead Edge Registration 0011-3857iR7105 / iR7095 / iR70861) Make the following selections in service mode so that the image marginwill be as indicated: COPIER > ADJUST > FEED-ADJ > REGIST.2) Exit the service mode.- if the margin is too large, increase the setting of REGIST (a change of10 will decrease the margin by 1 mm).- if the margin is too small, decrease the setting of REGIST (a change of10 will increase the margin by 1 mm).Lf=4.0+1.5/-1.0F-2-1542.2.24 Adjusting the Lead Edge Registration 0012-2061iR7095P1) Make the following selections in service mode so that the image marginwill be as indicated: COPIER > ADJUST > FEED-ADJ > REGIST.2) Exit the service mode.- if the margin is too large, increase the setting of REGIST (a change of 10will decrease the margin by 1 mm).- if the margin is too small, decrease the setting of REGIST (a change of 10will increase the margin by 1 mm).Lf=4.0+1.5/-1.0[1][1][1]imageL1[1][2][1]imageW1[1]02468100246810Lf
