Chapter 22-392.3 Checking the Connection to the Network2.3.1 Overview 0017-8463iR7105 / iR7095 / iR7086 / iR7095PThe information in this section applies when connecting the host machine to a network.If the user's network is in TCP/IP environment, use the PING command to see that the network settings are correct.There is no need to check the settings using the PING command if the use's network is in an IPX/SPX or Apple Talk environment.2.3.2 Checking the Network Connections 0010-9001iR7105 / iR7095 / iR70861) Go through the shut-down sequence to turn off the main power.2) Connect the network cable to the machine, and turn on the main power switch.3) Tell the user's system administrator that the machine has been installed, and ask him/her to make the machine's network settings.4) When the network settings have been made, go through steps 1) thorough 3) to turn off and then on the main power so that the settings will become valid.2.3.3 Checking the Network Connections 0012-2894iR7095P1) Go through the shut-down sequence to turn off the main power.2) Connect the network cable to the machine, and turn on the main power switch.3) Tell the user's system administrator that the machine has been installed, and ask him/her to make the machine's network settings.4) When the network settings have been made, go through steps 1) thorough 3) to turn off and then on the main power so that the settings will become valid.2.3.4 Using the PING Command 0010-9002iR7105 / iR7095 / iR70861) Make the following settings in service mode: COPIER > TEXT > NETWORK > PING.2) Type in the IP address using the control panel keypad, and press the OK key.3) Press the OK key.- When the check with the PING command is successful, 'OK' will be indicated; otherwise, 'NG' will be indicated.Perform the following work only if the machine is connected to a network.The following additional functions items must be set to 'ON' when makingnetwork settings:system administrator setup > network setup > change network settings/check connection.The following additional functions items must be set to 'ON' when makingnetwork settings:system administrator setup > network setup > change network settings/check connection.The information in this section applies when connecting the host machineto a network. If the user's network is in TCP/IP environment, use the PINGcommand to see that the network settings are correct. There is no need tocheck the settings using the PING command if the use's network is in anIPX/SPX or Apple Talk environment.
