Chapter 88-41F-8-878.11.10.4 Mounting the multiple curling prevention roller0010-9007iR7105 / iR7095 / iR70861) Set the multiple curling prevention roller assembly to the main body.2) Mount the rear fixing plate 2 and the rear fixing plate 1 in the order in-dicated; then, secure them in place with the mounting screw [3].F-8-88When mounting the multiple curling prevention roller, hook the two clawsof the rear fixing plate 2 on the three holes in the rear side plate; then, mountthe rear fixing plate 1 to secure.8.11.11 Manual Separation Roller8.11.11.1 Removing the Separation Roller 0010-9031iR7105 / iR7095 / iR7086F-8-89When removing the separation roller, pay attention to the bushing at thefront.It will slip off.Initially, the urethane sponge of the part is pink, and changes over time (ac-celerated if exposed to light).Its tone will change from pink to orange and to yellow; it is a general char-acteristic of urethane sponge, and no physical deterioration (in performance)exists because of changes in color, and the part is not identified by color.F-8-908.11.12 Manual Feed Tray paper sensor8.11.12.1 Removing the Manual Feed Tray Paper Sensor0010-9032iR7105 / iR7095 / iR70861) Open the manual feed tray unit, and remove the door tape from the ma-chine side.2) Remove the mounting screw [1], and detach the solenoid cover [3]. (Aclaw [2] is hooked on the L-shaped opening; pull it down lightly, andmove it as if to open it.)F-8-913) Disconnect the connector [1].4) Remove heater mounting screw [2], and detach the pickup roller re-leasing solenoid [3] together with the support plate.F-8-925) Remove the screw [1], and detach the connector cover [2]; then, discon-nect the connector [3].[1][2][3][4]Rear fixing plate 2[1][2][3][4][1]Urethane sponge pieces[1] [3][2][1][2][3]
