Obtaining the IP address for the IMMThis information provides instructions on how to obtain the IMM IP address.About this taskTo access the web interface to use the remote presence feature, you need the IPaddress or host name of the IMM. You can obtain the IMM IP address through theSetup utility and you can obtain the IMM host name from the IMM network accesstag. The server comes with a default IP address for the IMM of 192.168.70.125. Toobtain the IP address, complete the following steps:Procedure1. Turn on the server.Note: Approximately 10 seconds after the server is connected to ac power, thepower-on button becomes active.2. When the prompt Setup is displayed, press F1. (This prompt is displayedon the screen for only a few seconds. You must press F1 quickly.) If you haveset both a power-on password and an administrator password, you must typethe administrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Logging on to the IMM web interfaceThis information provides instructions on how to log on to the IMM web interface.About this taskTo log on to the IMM web interface, complete the following steps:Procedure1. On a system that is connected to the server, open a web browser. In theAddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Note: If you are logging on to the IMM for the first time after installation, theIMM defaults to DHCP. If a DHCP host is not available, the IMM assigns astatic IP address of 192.168.70.125. The IMM network access tag provides thedefault host name of the IMM and does not require you to start the server.2. On the Login page, type the user name and password. If you are using theIMM for the first time, you can obtain the user name and password from yoursystem administrator. All login attempts are documented in the system-eventlog.Note: The IMM is set initially with a user name of USERID and password ofPASSW0RD (with a zero in the word password, not the letter O). You haveread/write access. You must change the default password the first time you logon.3. Click Log in to start the session. The System Status and Health page provides aquick view of the system status.Chapter 3. Configuration information and instructions 153
