asu set SYSTEM_PROD_DATA.SysEncloseAssetTagaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa [--host ipaddress][--user userid][--password password]where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number ofthe server.Remotely over a LANThis information provides instructions on how to update the UUID remotely overa LAN.ProcedureTo update the UUID in the ASU command-line interface, enter the followingcommand:Note: If you omit any optional parameter, the default value is used.asu set SYSTEM_PROD_DATA.SysInfoUUID uuid --host ipaddress[--user userid][--password password]where:uuid is the user-assigned hexadecimal value, up to 16 bytes, that identifies theserver.ipaddressis the external LAN IP address of the IMM.userid is the IMM account name (1 of 12 accounts). The default is USERID.passwordis the IMM account password (1 of 12 accounts). The default is PASSW0RD(with a zero, not the letter O).To update the DMI/SMBIOS data, complete the following steps:1. In the ASU command-line interface, enter the following command:asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy --host ipaddress[--user userid][--password password]where:xxxx is the 4-digit machine type of the server.yyy is the 3-digit model number of the server.ipaddressis the external LAN IP address of the IMM.userid is the IMM account name (1 of 12 accounts). The default is USERID.passwordis the IMM account password (1 or 12 accounts). The default isPASSW0RD (with a zero, not the letter O).2. Enter the following command:asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz --host ipaddress[--user userid][--password password]where zzzzzzz is the 7-character serial number of the server.3. Enter the following command:Chapter 3. Configuration information and instructions 161
