ResultsIn-band automated boot recovery methodNote: Use this method if the BOARD LED on the light path diagnostics panel is litand there is a log entry or Booting Backup Image is displayed on the firmwaresplash screen; otherwise, use the in-band manual recovery method.1. Boot the server to an operating system that is supported by the firmwareupdate package that you downloaded.2. Perform the firmware update by following the instructions that are in thefirmware update package readme file.3. Restart the server.4. At the firmware splash screen, press F3 when prompted to restore to theprimary bank. The server boots from the primary bank.Out-of-band method: See the IMM2 documentation (Integrated Management ModuleII User's Guide) at http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5089484.For more information about UEFI-compliant firmware, go to http://www.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5083207&brandind=5000008.Automated boot recovery (ABR)This information provides instructions on how to use the automated boot recovery(ABR) feature.About this taskIf the server is booting up and the IMM detects problems with the server firmwarein the primary bank, it will automatically switch to the backup firmware bank andgive you the opportunity to recover the primary bank. To recover to the serverfirmware primary bank, complete the following steps.Procedure1. Restart the server.2. When the prompt press F3 to restore to primary is displayed, press F3 torecover the primary bank. Pressing F3 will restart the server.212 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
