Installing the optional ServeRAID M5110 SAS/SATA ControllerUse the information for instructions on how to install the ServeRAID M5110SAS/SATA Controller.About this taskJ5B1RAID cachecard connectorReleasetabCachecard bracketServeRAIDM5110 adapterPort 1 Port 0You can purchase an optional ServeRAID M5110 SAS/SATA Controller for Systemx. This adapter can be installed only in the PCIe slots listed in “Supportedadapters” on page 72. For configuration information, see the ServeRAIDdocumentation at http://www.ibm.com/supportportal/.Attention: Some cluster solutions require specific code levels or coordinated codeupdates. If the device is part of a cluster solution, verify that the latest level ofcode is supported for the cluster solution before you update the code.Note:v For additional information and notes about installing adapters see “Installing anadapter” on page 70.v Follow the general rule for connecting the SAS signal cables to the adapter anddrive backplane: port 0 on the adapter to port 0 on the drive backplane and port1 on the adapter to port 1 on the drive backplane (depending on the type ofdrive backplane you install in the server).To install the ServeRAID M5110 SAS/SATA adapter, complete the following steps:Procedure1. Read the safety information and installation guidelines, see “Safety” on pagevii and “Installation guidelines” on page 35.2. Turn off the server (see “Turning off the server” on page 22) and all attachedperipheral devices. Disconnect all power cords; then, disconnect all externalcables from the server.3. Remove the top cover (see “Removing the server top cover” on page 38).4. Remove the fan cage assembly (see “Removing the fan cage assembly” onpage 42).5. Remove the microprocessor and memory expansion tray (see “Removing themicroprocessor and memory expansion tray assembly” on page 305) or DIMMair baffle (see “Removing the DIMM air baffle” on page 232), whichever one isinstalled.Chapter 2. Installing optional devices 81
