What to do nextNote: If you boot to the operating system while in the IMM GUI and the message“Booting OS or in unsupported OS” is displayed under System Status → SystemState, disable Windows 2008 firewall or type the following command in theWindows 2008 console. This might also affect blue-screen capture features.netsh firewall set icmpsetting type=8 mode=ENABLEBy default, the icmp packet is blocked by Windows firewall. The IMM GUI willthen change to “OS booted” status after you change the setting as indicated abovein both the Web and CLI interfaces.Logging on to the IMM CLI interface using telnetUse this information for instructions on how to log on to the IMM CLI interfaceusing telnet.About this taskTo log on to the IMM CLI interface using telnet, complete the following steps:Procedure1. From the command prompt, type telnet; then, the IP address for the IMM towhich you want to log on to and press Enter.2. Type the USERID and PASSWORD for the IMM and press Enter.3. At the system prompt, type your command.Note: You can type help in the command prompt if you want to see a list ofcommands that you can use.4. When you are finished, type Exit, to exit the session.Logging on to the IMM CLI interface using SSHUse this information for instructions on how to log on to the IMM CLI interfaceusing SSH.About this taskTo log on to the IMM CLI interface using SSH, complete the following steps:Procedure1. Generate an SSH Server private key, see the Integrated Management Module IIUser’s Guide at http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5089484 for information on how to generate an SSHServer private key.2. Make sure that the SSH Server is enabled.3. From the command prompt, type ssh, then press Enter.4. Type USERID@IPADDRESS in the command prompt (where the USERID andIP ADDRESS is the user ID and IP address for the IMM to which you want tolog on to), then press Enter.5. Type the PASSWORD for the IMM and press Enter.6. At the system prompt, type your command.Note: You can type help in the command prompt if you want to see a list ofcommands that you can use.154 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
