Chapter 3. Configuring your xSeries 130 appliance server 19Using Windows Remote Terminal ServicesIf you do not want to use Web based Terminal Services, you can use WindowsRemote Terminal Services. To do so, you need to install the Windows RemoteTerminal Services Client on the remote workstation that you are using to manage yourappliance server. To install Windows Remote Terminal Services, do the following:Note: The workstation you use must be on the same logical and physical subnet asthe appliance server.1. Insert the Supplementary CD into your remote system CD-ROM drive (not theappliance server).2. Click Start g Run.3. In the Open field, type (with quotation marks, and substitute your CD-ROM driveletter for e)"e:\Terminal Services Client\Disk 1\setup.exe"Then, click OK to begin the Terminal Services Client Setup program.4. In each window that opens, accept the defaults. For additional information, seethe Microsoft Windows documentation. When the Terminal Services Client Setupprogram is completed, proceed to the next step.5. Check the workstation network TCP/IP protocol configuration settings.Note: By default, the appliance server uses DHCP. If you do not have a DHCPserver on the network, the appliance is assigned the IP address169.254.x.y (where x and y are random numbers) and a subnet mask of255.255.0.0.6. Connect your remote management system to the xSeries 130 appliance using theTerminal Services Client.7. In the Terminal Services Client window, type imodelserial (for example,i86545DX25A1234)where model is the model type of your appliance server and serial is the serialnumber that is located in the right side of the bezel. For more information on thelocation see Figure 1 on page 1.8. Click Connect.9. Log in to the xSeries 130 appliance server.Use the following case-sensitive user name and password to log in to terminalservicesIn the Username field, typeAdministratorand in the Password field, typepasswordAttention: Change these defaults to ensure the security of your system.The remote workstation is connected to the appliance server through TerminalServices. Complete documentation on how to use Terminal Services is found on theUM Services Web-page by clicking on the matching link.
