28 IBM xSeries 130: User’s ReferenceTo set the password override switch or jumper:1. Review the information in “Safety” on page vii.2. Turn off the appliance server and peripheral devices and disconnect all externalcables and power cords; then, remove the cover. See “Removing the cover” onpage 56.3. To set the override switch or jumper for your model:• 8654, Toggle switch 4 on switch block 1 on the system board to the positionopposite the current position. This clears the power-on password for one bootcycle.• 8672, If the CMOS jumper is installed, remove it to clear the CMOS and resetthe power-on password. If the CMOS jumper is not installed, then installing itwill clear the CMOS and reset the power-on password.Note: This means that you can now start or power-on the appliance server onetime without having to use the power-on password. But if you do not usethe Configuration/Setup Utility program to change or delete the password,the next time you start the appliance server, the original power-onpassword will be reinstated.4. Connect the appliance server to a power source, keyboard, monitor, and mouse.5. Restart the appliance server.Note: You can now start the Configuration/Setup Utility program and either delete theold password or set a new power-on password.Administrator passwordSelect this choice to set an administrator password. The administrator passwordprovides access to all choices on the Configuration/Setup Utility main menu. You canset, change, or delete both the administrator and power-on passwords and enable apower-on password to be changed by the user.Attention: If an administrator password is set and then forgotten, it cannot beoverridden or removed. You must replace the system board.
