Chapter 6. Installing options 57Figure 15. Removing the coverNote: You might need to remove the clear plastic shield to reach some parts inthe appliance server. For proper cooling and airflow, replace the clearplastic shield before replacing the cover.Attention: For proper cooling and airflow, replace the cover before turning onthe appliance server. Operating the appliance server for extended periods of time(over 30 minutes) with the cover removed might damage appliance servercomponents.7. Install all options before reinstalling the cover on the appliance server.Installing hard disk drivesYour appliance server supports two 26 mm (1-in.), slim, 3.5-inch hard disk drives.Model 8654 appliance servers support SCSI hard disk drives, while model 8672appliance servers support IDE hard disk drives. Before you install a hard disk drive,review the following:• Inspect the drive or drive tray for any signs of damage.• To maintain proper system cooling, do not operate the appliance server for morethan 2 minutes without either a drive or a filler panel installed in each bay.• Review the information in “Handling static-sensitive devices” on page 50.• Check the instructions that come with the drive for more information aboutinstalling your drive.Installing a SCSI hard disk drive in the model 8654Complete the following steps to install a SCSI hard disk drive in the model 8654:1. Review the information in “Safety” on page vii.2. Turn off the appliance server and disconnect all external cables and power cords.3. Remove the filler panel from the available hard disk drive bay.Cover releaselever Screws
