- 40 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setInstructions on how to change the height of the feet:- Loosen the height-adjustment lock by turning the clamping screw counter-clockwise.- Turn the height-adjustment screw (hexagon socket 4.0 mm) clockwise to raise the scanner.- Turn the height-adjustment screw counter-clockwise to lower the scanner.- Tighten the clamping screw after adjusting the correct height.Removing the Transport Protection from the Guide Rails12.7Langer EMV-Technik GmbH applies a thin layer of grease to all sliding rails so as to ensureappropriate corrosion protection during transport and storage. Remove this grease before puttingthe system into service.Figure 36: Cleaning the greased sliding rails with a paper towelUse dry towels made of cloth or fabric to remove the grease. Dispose of the towels under dueconsideration of the local, official regulations.Wash the grease off with water and soap if it comes into contact withyour skin!Prevent the grease from coming into contact with your clothes, skin, hair and eyes.Wash your hands
