- 72 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setNote: The probe sleeve can also be removed from the magnetic holder to facilitate the assembly ofthe near-field probe (Section 10.8). Thanks to the rear bore, the probe sleeve can be returned tothe magnetic holder and fastened in the correct position.Figure 105: Mounting the near-field probe on the probe holderConnecting a Near-Field Probe Directly to the FLS 106 PCB Scanner18.2.1If operated without a preamplifier, the RF measuring cable has to be connected to the near-fieldprobe's measurement output and directly to the input marked RF in on the Z-axis tower(Figure 106).Figure 106: Connecting the respective RF measuring cable to the near-field probe and the "RF in" connector on the Z-axis towerConnecting a Near-Field Probe with a Preamplifier18.2.2Note: The selection of the correct preamplifier depends on the measurement task and thenear-field probe used. Please contact Langer EMV-Technik GmbH should you have any queries(Chapter 25).Connect the preamplifier's SMA output directly to the input marked RF in on the Z-axis tower(Figure 107).Important: Only fasten the preamplifier by hand to prevent damage!
