- 57 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setAdjust the height and angle with the grub screws so that the device under test can be pushedunder the projecting part of the clamping piece. Align the device under test and fix the clampingpiece with the hexagon socket screw M6.Repeat the aforementioned steps for the second clamping piece on the opposite side of the deviceunder test.Figure 62: Device under test installed between two clamping piecesCheck that the device under test is held firmly enough so that it cannot slip away.Fastening a Circuit Board on the UH DUT Universal Holder16.2Installing the UH DUT16.2.1Note: Scratches and/or other traces may be left on the T-slot table if the clamping pieces arefastened too tight. Take due care.Place the UH DUT universal holder on the T-slot table precisely in the middle between two T-nuts(Figure 63).Figure 63: Positioning the UH DUTInsert a T-nut into each of the T-slots directly alongside the UH DUT and push them up to themiddle of the UH DUT.
