- 80 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setDismantling23General Information23.1At the end of its service life, the FLS 106 scanner has to be dismantled and disposed of in anenvironmentally friendly way.Unless a return and disposal agreement has been concluded with Langer EMV-Technik GmbH, thescanner has to be properly dismantled and recycled.Please note that only electrical specialists may work on electronic components and only therespective specialists may dismantle all other components.Safety Instructions for Dismantling23.2Danger due to improper dismantling!Risk of injury if instructions are not followed!Read Chapter 23 thoroughly before dismantling.Only use appropriate tools.Make sure that cables and electronics are voltage-free.Make sure that cables and electronics remain voltage-free during dismantling.Store dismantled components safely and sorted by material properties.Contact Langer EMV-Technik GmbH in case of uncertainties.Observe all applicable local health, safety and environmental regulations when dismantling thescanner.Procedure of Dismantling23.3Switch the scanner off and disconnect the mains cable before dismantling.Recommended sequence:(1) Dismantling of attachments(2) Dismantling of subassemblies(3) Removal of electrical cables, circuit boards and motorsWarning!
