- 78 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setRemoving the Preamplifier / BT 706 Bias Tee21.5First remove the measuring cable from the signal input of the pre-amplifier / bias-tee and the powersupply cable from the 12 V input on the Z-axis tower by hand. Next unscrew thepreamplifier / bias tee from the connector marked RF in on the Z-axis tower by hand.Store the preamplifier / bias tee and the associated cables in the corresponding case.Removing a Device Under Test from the T-Slot Table21.6First loosen all of the clamping pieces (screws M6, hexagon socket 5 mm) and then remove thedevice under test from the T-slot table.Removing a Circuit Board from the UH DUT21.7After loosening all attached claws (claw 01 and/or claw 02) (screw M3, 2.5 mm hexagon socket),remove the circuit board from the UH DUT universal holderRemoving the UH DUT21.8First loosen the clamping pieces (screws M6, hexagon socket 5 mm) and then remove theUH DUT from the T-slot table.Removing the GND 2521.9Grasp the edge of the GND 25 ground plane that is installed on the GND 25 holder with bothhands and raise it. Stow it away safely.Removing the GND 25 Holder21.10Unscrew the two screws M6 (hexagon socket 4 mm) to remove the GND 25 holder. Then raise theGND 25 holder and remove the T-nuts from the T-slot table via the T-slot openings.Removing the DM-CAM Microscope Camera21.11Disconnect the HR10 plug from the HR10 connector marked "Camera" on the scanner's Z-axistower. Release the plug's quick-action coupling to do so.Then loosen the small, silver-colored knurled screw and pull the microscope camera out fromabove.You can also remove the camera screw from the DM-CAM holder.3 camera holder if required. Todo so, hold the black knurled nut with one hand and loose the large silver knurled screw on theback of the DM-CAM holder.3 with the other hand.After removing the camera screw, screw the large silver knurled screw back to the black knurlednut and stow away safely.Removing the DM-CAM Holder.3 Camera Holder21.12To remove the DM-CAM holder.3 loose the two M4 knurled screws on the top of the rotary unit.Remove the DM-CAM holder.3, stow away safely and screw the two M4 knurled screws back onthe rotary unit.
