- 77 / 83 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setAfter Completing the Measurement20After completion of the scan, the probe should be allowed to travel up until it has reached a safedistance to the DUT. If an ICR probe has been used, allow the probe to travel up until the completeprotective cap can be put on the ICR probe tip and locked into place.The scanner can then be switched off properly.Disassembling after Completing the Measurement(s)21Removing the ICR Probe21.1Material damage due to lack of protection of the ICR probe!Before the ICR probe is removed from the rotary unit, the protective cap must be pushedover the probe tip and locked in place. This will prevent damage to the probe tip as far aspossible.Remove the connected ICR probe from the rotary unit's rotary ring by loosening the twoM3 knurled screws. To do so, hold the probe with one hand and loosen the knurled screws with theother.Keep hold of the ICR probe, disconnect the SSMB-SSMB depth test cable from the ICR probe'sSSMB connector with your free hand and unscrew the SMA-SMA measuring cable from theICR probe's SMA connector.After all cables are removed, you can put the ICR probe in its corresponding case for safe storage.Removing the Near-Field Probe21.2Loosen the installed near-field probe together with the probe sleeve from the SH 01 magneticholder. If desired, the fastening screw on the probe sleeve can be loosened and thenear-field probe can be removed from above.Disconnect the connected measuring cable and put the near-field probe in its corresponding casefor safe storage.Removing the SH 01 Probe Holder from the Rotary Unit21.3First disconnect the connected SSMB-SSMB cable from the SH 01 probe holder. Then remove theSH 01 from the rotary unit by loosening the knurled screws M3.Removing the SH 01 Probe Holder from the Aluminum Bracket21.4First disconnect the connected SSMB-SSMB cable from the SH 01 probe holder. Then remove theSH 01 from the aluminum bracket by loosening the two M3 countersunk-head screws on themounting bracket of the SH 01.!Caution!
