User Guide202www.nec-computers.comSelected [Use Existing Partition] at [System Partition], but the OS is installed in thewhole area of the disk.■ Is there any other partition than the partition to re-use (excluding maintenancearea)? If no other partition exist, the setup will reserve the whole area of the disk toinstall operating system.Specified to join the Domain, but the system is installed as Workgroup.- When the setup fails to join the Domain during the installation, it will install thesystem as Workgroup. Open [System] in Control Panel to specify joining theDomain.Specified large value as partition size, but when Windows 2000 is actually started,the system partition is created by 4095MB.■ Is the [Partition Size] specified by the value larger than the real area?- If you want to create one partition in all area of the hard disk (excluding themaintenance area) to install the OS, specify [All Area].■ Are you specifying over 200GB for the partition size?- Be sure to specify less than 200GB for the partition size.Windows 2000 started with different display resolution from the specified value.- If the specified display resolution can not be used, the system will use the near-est value or the default value of the driver.Entered the incorrect Product ID/CD key.- Even if you entered the incorrect Product ID/CD key, Express Setup will start.However, the setup will stop and asks you to re-enter the correct value. Also inthis case, input request will occur when rebooting after GUI setup completedduring Express Setup. If these 2 inputs are done correctly, there is no problemon Windows 2000 setup.Unable to specify the details of Network adapter.- In Express Setup, you can not specify the details of Network adapter. Specifythem from Control Panel after starting Windows 2000.Windows 2000 is started with Network adapter that has not been specified duringExpress Setup- Windows 2000 will install the recognized Network adapter specified as defaultvalue. If you want to modify the specification, it can be done from ControlPanel after starting Windows 2000. Also, the Network adapter that has beenspecified during Express Setup but that is not connected will not be setup,though the protocol will only be installed.
