User Guide296www.nec-computers.comStarting NEC ExpressBuilderThe following procedure instructs you to start NEC ExpressBuilder.CautionDo not remove the NEC ExpressBuilder CD-ROM while NECExpressBuilder is running.1. Turn on peripheral devices and the server in this order.2. Insert the NEC ExpressBuilder CD-ROM supplied with your server into theoptical disc drive of your server.3. Ensure that the floppy disk drive is empty.4. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NECExpressBuilder. (You may also turn off and then on again to reboot the server.)NEC ExpressBuilder boots up displaying the top menu.DOS-Based NEC ExpressBuilder MenusExpress Setup"Express Setup" is intended for initial setup of the server. Its automatic installationmode guides the user easily through the process by detailing specific hardware featuresand providing screen prompts for software selection and configuration. The programloads the utilities and drivers, applies RAID settings, partitions the disk, and installs thedesired operating system.If you install Windows Server 2003 or Windows 2000, after a few tasks are completed,all that remains to be done is to remove the NEC ExpressBuilder CD-ROM and installthe Windows CD-ROM, input a product ID number, and acknowledge the licenseagreement.
