User Guide260www.nec-computers.comInstalling with the OEM-FD for Mass Storage DeviceThis section explains how to setup with the OEM-FD. You usually do not have to do asfollows. If you want to install other boards by using a driver floppy disk, set the serveras follows. Detailed information is provided in the manual of the mass storage device.Installation of mass storage device not supported by ExpressSetupIf you would like to install the OS when the system has new mass storage device notsupported by NEC ExpressBuilder, you have to setup as follows.1. Read the manual supplied with the mass storage device before setting theserver.2. If the mass storage device is disk array controller, configure the RAID systembefore running the NEC ExpressBuilder.3. Boot the system from NEC ExpressBuilder CD-ROM.4.(a) When the message “Do you want to use the parameters file...”appears , select “Yes”.(b) When the dialog of Disk array configuration appears, check “UseExisting Array”(c) Check “Apply OEM-FD for Mass storage device”5. Copy the driver for the mass storage device in the ExpressSetup.6. Insert the FD attached the mass storage device into the FD drive.7. Follow the on-screen instructions to continue the ExpressSetup.
