User Guide283www.nec-computers.comWindows Server 2003 x64 Editions Clean InstallationThis section explains how to perform a clean installation of Windows Server 2003 x64Editions.1. Turn the system on.2. Insert the Windows Server 2003 x64 Editions CD-ROM in the optical devicedrive.3. Press Ctrl + Alt + Delete to reset the system.After a bootable operating system has been installed on the hard disk, pressEnter while the message "Press any key to boot from CD..." is displayed at thetop of the screen.If no bootable operating system exists on the hard disk, this step is unnecessary.The Windows Server 2003 x64 Editions setup screen will be displayed. If thescreen is not displayed, Enter was not pressed properly.Retry after turning the system off and then on again.4. If a RAID or SCSI controller is installed, press F6 in a few seconds when thewindow is in one of the following states:– "Setup is inspecting your computer's hardware configuration..." is displayed.– A screen with a solid blue background is displayed.Note: There is no visible indication on screen when F6 hasbeen pressed.5. When the following message is displayed, press S.The following message is then displayed.Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.Please inert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:*Press ENTER when ready.
