User Guide273www.nec-computers.comGraphics Accelerator DriverThe drivers for the graphics accelerator cards that are installed in the server will setupautomatically.If you remove an additional graphics card, make sure to remove its correspondingdriver.Should it be necessary to install manually the drivers, follow the procedure below.If you want to use an optional graphics acceletaror card, setup the card according towhat is written in the card’s documentation.1. Insert the NEC ExpressBuilder CD-ROM into the DVD-ROM drive.2. Click Start menu, point to [Programs], [Accessories] and click [WindowsExplorer]3. Run "SETUP.EXE" in the following directory.To install a standard graphics accelerator driver: drive Letter>:\WINNT\DOTNET\VIDEO\MATROX/SETUP.EXETo install a graphics accelerator (N8105-45) driver::\WINNT\DOTNET\VIDEO\ES1000/SETUP.EXE4. Follow the on-screen instructions to continue the installation. If a message“Digital signature could not be found” appears, select Yes to continue.5. Remove the NEC ExpressBuilder CD-ROM from the DVD-ROM drive,follow the on-screen directions and restart the system.Installing SCSI Controller DriversUpdate the drivers for your system using the NEC ExpressBuilder CD-ROM shippedwith your system.The SCSI drivers will be installed automatically.Installing a Disk Array Controller Driver (SecuRAID 114, SecuRAID121)To install these controllers on a system running under Windows Server 2003, connectthe controller and take the following steps to install the driver:1. Start [Device Manager] from [Start] menu → [Control Panel] →[Administrative Tools] → [Computer Management].
