|
Securing your network 107show eapol multihost non-eap-mac interface []where is the list of ports you want to view. You can enter a singleport, a range of ports, several ranges, or all. If you do not specify a portparameter, the command displays all ports.The display lists the ports and the associated allowed MAC addresses.Viewing current non-EAPOL host activity To view information aboutnon-EAPOL hosts currently active on the switch, use the following commandin Privileged EXEC, Global configuration, or Interface configuration mode:show eapol multihost non-eap-mac status []where is the list of ports you want to view. You can enter a singleport, a range of ports, several ranges, or all. If you do not specify a portparameter, the command displays all ports.show eapol multihost status command The show eapol multihoststatus command displays the multihost status of eapol clients onEAPOL-enabled ports.The syntax for the show eapol multihost status command is:show eapol multihost status [] [d>]"show eapol multihost status command parameters and variables" (page107)"show eapol multihost status command parameters and variables"(page 107) describes the parameters and variables for theshow eapolmultihost status command.show eapol multihost status command parameters and variablesParameter Descriptioninterface-id Displays the interface IDinterface-type Displays the type of interface usedThe show eapol multihost status command is executed in thePrivileged EXEC command mode.Configuring MultiHost Single-Autentication (MHSA) To configureMHSA support, do the following:1. Enable MHSA globally on the switch (see "Globally enabling support forMHSA" (page 108)).Nortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks. PreviousNext |