Nortel 2526T Configuration

Also see for 2526T: Reference guide Quick install guide

Contents

Securing your system 75snmp-server host for the new-style table commandThe snmp-server host for the new-style table command adds a trapreceiver to the new-style configuration (that is, to the SNMPv3 tables). Youcan create several entries in this table, and each can generate v1, v2c, orv3 traps. You must previously configure the community string or user thatis specified with a notify-view. The syntax for the snmp-server hostfor the new-style table command is:snmp-server host [port <1-65535>]{|v2c

v3 {auth|no-auth|auth-priv} }The snmp-server host for the new-style table command is executed inthe Global Configuration command mode.Table 34 "snmp-server host for the new-style table command parametersand variables" (page 75) describes the parameters and variables for thesnmp-server host for the new-style table command.Table 34snmp-server host for the new-style table command parameters and variablesParameters and variables Description

Enter a dotted-decimal IP address of a host tobe the trap destination.port <1-65535> Sets SNMP trap port.

If you do not specify a trap type, this variablecreates v1 trap receivers in the SNMPv3 MIBs.You can create multiple trap receivers withvarying access levels.v2c Using v2c creates v2c trap receivers in theSNMPv3 MIBs. You can create multiple trapreceivers with varying access levels.v3 {auth|no-auth|auth-priv}Using v3 creates v3 trap receivers in theSNMPv3 MIBs. You can create multiple trapreceivers with varying access levels by enteringthe following variables:• auth|no-auth —Specifies whetherSNMPv3 traps can be authenticated.• auth-priv—This parameter is onlyavailable if the image has full SHA/DESsupport.Nortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.