Nortel 2526T Configuration

Also see for 2526T: Reference guide Quick install guide

Contents

Securing your system 39show password aging-time day commandThe password aging-time day command shows the configuredpassword aging-time.The syntax of the command is:show password aging-timeThe following shows a sample output for this command:2550T (config)#show password aging-timeAging time: 100 daysConfiguring the number of password logon attemptsThe telnet-access retry command configures the number of times auser can attempt a password:.The syntax of the command is:telnet-access retry where is an integer in the range 1-100 that specifies the allowednumber of failed logon attempts. The default is 3.If a new aging time is set from the CLI, the password aging counters arenot reset.Configuring the IP manager listWhen enabled, the IP manager list determines which source IP addressesare allowed access to the switch. No other source IP addresses haveaccess to the switch. You configure the IP manager list by using thefollowing commands:• "show ipmgr command" (page 39)• "ipmgr command for management system" (page 40)• "no ipmgr command for management system" (page 41)• "ipmgr command for source IP address" (page 42)• "no ipmgr command for source IP address" (page 42)show ipmgr commandThe show ipmgr command displays whether Telnet, SNMP, and Webaccess are enabled; whether the IP manager list is used to control accessto Telnet, SNMP, and the Web-based management system; and the currentIP manager list configuration. The syntax for the show ipmgr command is:show ipmgrNortel Ethernet Routing Switch 2500 SeriesSecurity — Configuration and ManagementNN47215-505 (323165-B) 02.01 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.